The Reason Of Jaw Crusher Yield Could Not Reach The Standard
The Reason Of
Jaw Crusher Yield Could Not Reach The Standard
Henan SEBON International co.,ltd tutorial: The reason of Jaw Crusher yield could not reach the standard.
Why jaw crusher yield could not reach the standard sometimes? To this, SEBON relevant personage points out, jaw crusher factory production standards are very strict standard. Sometimes it appears this kind of the production not reach the standard, and the reason has various aspects, for example:
1. Material hardness or toughness beyond instructions prescribed scope;
2. Motor connection position against, moving jaw clockwise spin, or motor triangle meet method into star;
3. Discharging mouth smaller than the specified limit;
4.
Jaw plate shift, tooth crest and tooth crest relative;
5. Voltage is too low;
6. The clearance between moving jaw and bearing become large after wearing, and bearing outer ring rotate relatively ;
After understand the reason, the solution is very simple and clear.
Elimination methods:
1. Change or add crusher;
2. Exchange motor connection;
3. Discharging mouth adjust to manual nominal discharging prescribed mouth and increase the crusher for finely crush;
4. Check the sizes from gear plate to tooth, jaw plate are must be replaced if it doesn’t conform to the standards. Reset the relative position of fixed jaw and moving jaw to prevent shifting;
5. Raise the work site voltage to adapt host overloaded requirements;
6. Replace bearing or move the jaw.
